LUBEMAXX Engine Flush is added to the old fluid and is left to circulate through the engine. Just warm the engine to operating temperature and add LUBEMAXX Engine Flush. LUBEMAXX Engine Flush uses the old oil as a delivery mechanism where carefully selected additives, dissolved in oil, gradually and thoroughly remove deposits from the engine, removing them from the engine by draining the old oil.

Warm up the engine and turn it off. Add additive to the oil pan and restart the engine. Allow the engine to run stationary for at least 5 minutes. For best results, run the engine stationary for 15 minutes. Then drain the engine oil and refill the engine with OEM recommended engine oil. It is recommended to use a 500 ml bottle of LUBEMAXX Engine Flush to clean the engine oil from 3.5 to 6.5 liters. It is recommended to use LUBEMAXX Engine Flush at the service intervals specified in the user manual. You do not need to remove the old oil to make room for the additive.

LUBEMAXX Engine Flush removes varnish and deposits without softening seals or gaskets. LUBEMAXX Engine Flush can also be used in engines where the timing belt runs in oil (belt in oil). Debris and deposits can be dissolved by the additives or captured by the oil filter. Therefore, it is recommended to change the oil filter after performing an engine flush.

TYPICAL PHYSICAL DATA               

Color / appearance                       yellow  

Viscosity at 40 °C                          15.9 mm²/s

Viscosity at 100 °C                        3.5mm²/s

Density at 20 °C                             0.8668 g/l

Viscosity index                               95

Flash point                                    164 °C

Pour point                                     -30 °C